The best circular saw blade for cutting through laminate for a kitchen counter is one with many fine teeth — at least 40. Blades with carbide tips tend to last longer than regular steel. In addition, you should choose a narrow blade, or one with thin kerf, as it’s called in saw talk.
What jigsaw blade do I use to cut a countertop?
The Bosch T101BR jigsaw blade is an ideal choice for cutting laminate materials. The blade cuts on the down stroke, not on the upstroke, the “R” in the product code referring to its “reversed” teeth. This is a popular blade often referred to as a worktop blade.6天前
What do you cut Formica countertops with?
Cutting a post-form laminate countertop to length requires a clean, straight cut. The best DIY tool for the job is a circular saw with a fine-tooth carbide blade made for laminate (the same blades are typically sold for non-ferrous metals and other types of plastics). You can also use a jigsaw with a fine-tooth blade.
Can I cut a laminate countertop with a circular saw?
To cut through laminate countertops, you can use a hand saw, but a circular saw makes the job much quicker. Because a circular saw can produce jagged edges and chip the laminate, your best bet is to lay the laminate face-side down and cut from the back to the front.
What blade do you use to cut Formica?
Formica is best cut with a fine-tooth carbide circular saw or jigsaw blade. Always start on the finished side of the Formica, or the side that will show when you’ve finished your installation. If you start cutting from the back side, the saw teeth can leave a chipped or jagged edge on the finished surface.
How many teeth do I need to cut laminate?
Diamond-tipped blades that are made for laminate and fiber cement usually have a low number of teeth to reduce the dust produced by cutting cement. However, typical circular and miter saw blades that are used for laminate will have 80 to 100 teeth for fine, precision cutting.
How do you cut laminate with a knife?
Turn the laminate one-quarter turn and align the square along the next cut line. Draw the knife across the surface, applying firm pressure, two or three times. Shift the score line to the table edge and break the laminate again. Repeat for any additional cuts.
How do you cut Formica countertops without chipping?
Outfit the jigsaw with a blade designed for use with laminate or particle board. Then, use a drill with a spade or paddle bit to drill a starting hole for your countertop cutting jig. Cut around the outline, and then remove the remaining tape to reveal the clean edge.