Circular saws can be used for all types of wood product cutting–lumber, plywood and paneling. The saws can cross-cut and rip cut. … The blade doesn’t need to be oiled very often; you can coincide the oiling with blade replacement, but a spot of oil on the inner washers will keep the saw running better and more safely.
Can you use wd40 on circular saw?
There are several moving parts in a circular saw which must be properly lubricated after all the chips and dust have been removed. We perform all this lubrication using WD-40 Specialist Dry Anti-Friction PTFE Lubricant. … Also externally lubricate the sliding holes of any extendable surfaces.
Do circular saws need maintenance?
Similar to table saw maintenance, you should inspect your circular saw and its blades before every use. … Check the air vents to make sure they are clear and test the blade guard to make sure it works properly. You should also check all of the knobs and levers before turning the saw on.
Should I oil my saw?
Remember to oil the handle: It’s necessary to frequently oil the handle of the saw, particularly if it’s wooden. You can some boiled linseed oil to do this to prevent moisture and dirt build-up. Also, make sure to remove the handle and clean out the slot if the part attached to the blade shows signs of rust.
How long will a circular saw last?
They can last between 12 and 120 hours of continuous use, depending on the quality of the blade and material they’re used to cut.
How do you keep a saw blade from rusting?
Wipe blade or bits clean with a soft cloth. If cleaning with water or degreaser, wipe clean and dry thoroughly to prevent rusting. Keeping saw blades and bits clean from resin and pitch build-up provides for cleaner more precise cuts.
How do you clean an old circular saw?
Lay the blade flat in your pan or container, so it is completely submerged in the cleaning solution. Leave it to soak for about 10 minutes. Clean. After 10 minutes, scrub the blade’s teeth and any gunky areas with an old toothbrush, small brass brush, hard bristle brush, or steel wool.
Should a circular saw blade touch the guard?
13. If saw is accidentally dropped, lower guard may be bent. Raise the lower guard only with the lower guard lift lever and make sure it moves freely and does not touch the blade or any other part, in all angles and depths of cut.